福建省重点城市路面尘负荷及化学组成研究

采集并分析了福建省重点城市厦门、漳州、泉州和莆田城区具有代表性的57个地面扬尘和16个土壤样品的26种无机元素、8种水溶性离子和碳成分等组成.不同城市粒径≤100μm的路面尘负荷平均值在6.99 g.m-2与10.11 g.m-2之间,而粒径≤2.5μm的路面尘(PM2.5)负荷平均值在4.0 mg.m-2和12.5 mg.m-2之间.不同城市土壤尘和路面尘PM2.5中浓度最高的元素都是Si、Ca、Al、Fe和K,路面尘中Ca元素明显富集,而主要人为来源的重金属元素如Cu、Pb、Zn、Cr在路面尘PM2.5中的浓度显著高于土壤尘.漳州城区路面尘PM2.5中二次离子NH4+、NO3-和SO24-的含量明显高于其它地区,厦门、漳州和泉州城区路面尘PM2.5中Mg2+和Ca2+之间都存在显著的正相关关系.四城市路面尘中有机碳(OC)的含量均高于济南、石家庄以及北京地面扬尘OC的含量,元素碳(EC)的含量均低于北京地区路面扬尘EC的含量.泉州和莆田两地OC和EC的相关性较好,说明路面尘中OC和EC有相同或相似的来源.质量平衡结果显示泉州和莆田路面尘PM2.5中含量最高的是土壤尘,其次为有机物.按化学组成特征对路面尘PM2.5进行聚类解析,得到受大气沉降影响、受土壤尘影响、受大气沉降和土壤尘共同作用以及受土壤尘和建筑尘共同作用4类样品.     

SCREEN3模型在大气环境管理中的应用研究

基于高斯扩散的单源估算模式SCREEN3计算佛山市环境统计企业的SO2排放最大落地浓度距离,发现全市工业企业SO2排放最大落地浓度距离为0.4~13.5 km.其中水泥和火电等高架源的最大落地浓度的距离最远.佛山市及五区纳入环境统计的重点废气排放企业平均的SO2排放最大落地浓度距离为2.9~4.9 km,能直接影响国控监测点位的企业合计37家,其中40%为高明区的企业.该结果证明加强空气质量国控监测点位周边至少5 km内废气排放企业的督查有利于空气质量的改善.     

MBR＋纳滤＋反渗透工艺处理垃圾渗滤液实验研究

摘要：结合青岛市某生活垃圾处理场工程实例,介绍了MBR工艺处理垃圾渗滤液的工艺流程、原理等,分析了MBR工艺处理垃圾渗滤液的特点和优势。垃圾渗滤液经过MBR工艺处理,生化部分采用前置反硝化／硝化工艺,再经纳滤／反渗透等膜分离技术和其他方法处理,最终流出液水质可以达到《生活垃圾填埋场污染控制标准》（GB16889—2008）。     

多层次灰色综合评价法在企业清洁生产方案研选中的应用

针对国内清洁生产方案在选择过程中存在的主观性和不确定性,结合清洁生产审核中的实际问题,将层次分析法的思想融入灰色关联度分析法中,并结合某电镀厂筛选清洁生产方案的案例,对多层次灰色综合评价法模型的求解进行验证。通过验证证实了多层次灰色综合评价法能够解决多准则多方案选择过程中主观因素影响过大的问题,为清洁生产多方案的优选问题提供了科学合理的研究方法。     

Polybrominated diphenyl ether in the East Asian environment: a critical review

Polybrominated diphenyl ethers (PBDEs) have been extensively used as flame retardants in consumer goods. Sufficient evidence shows that PBDEs have been rapidly accumulating in the environment worldwide. In Asia, deca-bromodiphenyl ether has been produced and used in large quantities, while penta-BDE has largely ceased in the mid-1990s. This paper summarizes and critically reviews the status of PBDE pollution in East Asia, with emphases on the comparisons with Europe and North America and the interpretation of the differences. In general, the concentrations of PBDEs in atmosphere, sludge, human and biological samples of East Asia are comparable to or lower than those in Europe and North America. However, in the sediments of waters near densely populated and heavily industrialized areas, PBDE levels are among the highest ever reported in the literature. In Japan and China, concentrations of PBDEs in sediment cores showed an increasing trend for the past 20-30 years. Also, PBDEs levels in human breast milk in Japan increased about 10-fold in the past 20 years. The presence of PBDEs in fur seal has increased about 150-fold in 1994 than that in 1972. Regional and inter-continental transport cannot be confirmed due to insufficient information. However, the detection of a number of PBDE congeners in a pristine lake on the Qinghai-Tibet Plateau may be an evidence of their long-range transport.     

Quantitative method to determine the regional drinking water odorant regulation goals based on odor sensitivity distribution：Illustrated using 2-MIB

Taste and odor （T/O） in drinking water often cause consumer complaints and are thus regulated in many countries. However, people in different regions may exhibit different sensitivities toward WO. This study proposed a method to determine the regional drinking water odorant regulation goals （ORGs） based on the odor sensitivity distribution of the local population. The distribution of odor sensitivity to 2-methylisobomeol （2-MIB） by the local population in Beijing, China was revealed by using a normal distribution function/model to describe the odor complaint response to a 2-MIB episode in 2005, and a 2-MIB concentration of 12.9 ng/L and FPA （flavor profile analysis） intensity of 2.5 was found to be the critical point to cause odor complaints. Thus the Beijing ORG for 2-MIB was determined to be 12.9 ng/L. Based on the assumption that the local FPA panel can represent the local population in terms of sensitivity to odor, and that the critical FPA intensity causing odor complaints was 2.5, this study tried to determine the ORGs for seven other cities of China by performing FPA tests using an FPA panel from the corresponding city. ORG values between 12.9 and 31.6 ng/L were determined, showing that a unified ORG may not be suitable for drinking water odor regulations. This study presents a novel approach for setting drinking water odor regulations.     

建设项目环境影响后评价的主要内容及存在的问题研究

根据《中华人民共和国环境影响评价法》的有关条款,探讨了建设项目环境影响后评价的定义、适用对象、工作内容、工作程序。同时,结合多年的环境管理经验,分析了典型行业环境影响后评价的重点,并指出了目前中国建设项目环境影响后评价存在的问题,提出了改进和完善的建议。实践表明,开展环境影响后评价有助于提高环境管理决策水平。     

旋流分离器油水分离效率的模拟研究

采用计算流体力学的方法,探讨了操作条件和物料特性对旋流分离器分离油水效率的影响。旋流器为单锥双入口,其主直径为50 mm,锥角为5.5°。模拟过程中,采用商业用软件‘Fluent 6.3’中的雷诺应力模型和欧拉多相流模型来模拟不同条件下油水旋流分离器的分离性能。模拟结果表明,对于本研究的油水旋流分离器,最佳的分流比是10%,最佳的油滴浓度是0.5%(V/V)。在最佳的分流比和油滴浓度下,当进口流速为10.46 m/s时,油水旋流分离器可将15μm的油滴去除80%以上,油滴的分离界限粒径d50(50%的分离效率)为9.2μm。在模拟的基础上,用统计软件STATISTICA6.0对分离效率与操作条件和物料特性之间的关系进行拟合。通过拟合式预测的分离效率与实测值相吻合,误差小于15%。     

改进型波形潜流人工湿地处理猪场废水

提出了一种改进型波形潜流人工湿地(improved wavy subsurface flow constructed wetland,IW-SFCW)并研究了该湿地系统在5个水力停留时间(hydraulic retention time,HRT)(2、3、4、6和8 d)下对猪场废水的处理效果。结果表明,该湿地系统对猪场废水中各污染物有较好的去除效果。在水力停留时间为4 d,进水COD、TN、NH4+-N和TP浓度分别为511、120、110和10 mg/L左右时,该湿地系统对COD、TN、NH4+-N和TP的去除率分别为86.0%、54.4%、70.1%和91.6%。此外,该湿地系统对废水中COD、TP的去除效率随水力停留时间的延长逐渐提高,在HRT=8 d时去除效果最好,去除率分别达到92.7%和96.8%;但对TN、NH4+-N的去除率却随水力停留时间的延长出现先上升后下降的趋势,在HRT=4 d时去除率最高,分别为54.4%和70.1%。     

IC反应器处理MTO废水的中试研究

中试研究了内循环(IC)反应器处理甲醇制烯烃(MTO)废水的启动和运行过程,同时考察了颗粒污泥的性状及沼气产量的变化情况。试验过程运行稳定,系统抗冲击性强。以絮状污泥为接种污泥,经过131 d的启动和运行,IC反应器的COD去除负荷可达10 kg/(m~3·d)以上,COD去除率可达90%以上。IC反应器中的成熟颗粒污泥形状规则、密实、粒径大、沉降速率快。IC反应器的沼气产量符合理论预期。